Our full height ply lining panels are designed to sit outside the standard recess, they therefore are not fixed with clips, this does however offer a professional seamless camper van finish. Although a little trickier to fit, the full height offeres are far better finish. We have listed a few ways professionals ply line below. We recommend two people for all options

1. Small black panhead screws-

Firstly, carpet the panels and the areas in which the panels will not cover, then simply screw them to the metal work using small black pan head screws. The screws are barely visible within the carpet and this option allows the removal on the panel if necessary. You may find it helps to pre-drill with a 2.5 metal bit. We recommend two people to carry out the fitting.

2. Secret screw-

As before, carpet the panels and the areas in which the panels will not cover. Then make a small V shaped cut in the carpet with a sharp Stanley knife, as we only use 6mm you can then screw the panels with a small headed counter sunk screw, finally butt the carpet over the screw head for a seamless finish

3. Carpet drop-

Firstly, screw all uncarpeted ply into position with counter sink screws, then carpet drop the full side of the van starting from the top. Individual doors will still require steps 1 or 2

VW T5/6 single slider 

Lower OS panel, lower NS sliding door, 2 x full height rear quarters, 2 x seat belt covers, lower barn doors or tailgate

VW T5/6 twin slider

2 x lower sliding doors, 2 x full height rear quarters, 2 x seat belt covers, lower barn doors or tailgate

FTC 2014-2024 single slider 

Lower OS panel, lower NS sliding door, 2 x full height rear quarters, lower barn doors or tailgate

FTC 2014-2024 twin slider

2 x lower sliding doors, 2 x full height rear quarters, lower barn doors or tailgate